GOOD NEWS. . . . The PICTURE UPLOAD FUNCTION IS WORKING !!! The tech folks at the parent company have been able to remedy the issue. You can upload pictures once again. Thank you for your patience.
I looked at the felpro set but I couldn't justify the cost. The machine shop did do a good job! But that's where alot of the funds went so I ended buying most of my parts from rock auto on the cheap! I'm pretty confident though in the build.
Hey that's awesome appreciate the information. I assume the differences are more corrosion resistant?
I guess that makes sense that there would be rotted put head gaskets. Well I hope my gaskets hold up! I mean the engine as a whole is made out of cast iron so have you seen them usually last...
I can appreciate that. Is this from experience?
I actually did use a composite head gasket. I figured if the gasket fails then that'll be my que to upgrade to a v8 🤣.
Thanks Chris!
1. I did remove the drive.
2. I did alot of research before I made my decision on this. Seems like everyone's opinion is different but I went with automotive head gaskets. Seems like alot of marine companies are selling snake oil also it'll only see fresh water.. I'm sure I'll...
How's it going everyone. First time posting! This is my first boat! I've been working on cars since I was young though so I'm very knowledgeable when it comes to wrenching.
I bought a 1988 Regal Medallion 185 a couple months ago with a blown motor. Paid 1000 for it. The previous owner removed...
