Recent content by imported_Skinny

  1. I

    75 hp Mercury Motor Mount Replacement

    I have a 1993, 75 Hp Mercury outboard. Salt water has eaten the two lower motor mounts up (Dyna-Float System) ? the mounts that hold the drive shaft housing to the swivel bracket lower yoke. In order to replace the lower mounts I assume you have to take the two lower nuts off at the bottom...
  2. I

    Terminating the gas oil injection

    I have a 1993, 75 hp Mercury. I'd like to disconnect the automatic oil injection to the gas and manually add the oil to my gas tank like the old days. Is there a protocol/process for disconnecting the automatic oiler without ruining it (i.e., the metering system, etc.) in case I want to begin...
  3. I

    How do you disconnect the automatic gas oiler?

    I have a 1993, 75 Hp mercury. I'd like to terminate the oil injection and premix the oil with my gas. Anyone know how to terminate the oil injection without ruining it? Thanks, Scott
  4. I

    Fuel Gauge Repair

    First off, thanks Arks and Dunaruna for your feedback on my earlier post - it had a typo in it - here's a more accurate and detailed posting. I have a 1983 Renken and a 1985 Chris Craft. Both have the exact same name brand instruments on their dashboards. The only sign of a company name or...
  5. I

    Fuel Gauge repair and manufacturer

    I have a 1983 Renken and the only sign of a company name or trade mark on the dash instruments is a "T". Anyone know what company this is and what the ohm range the fuel gauge operates? The fuel gauge is non operative but when I replaced it with a teleflex it still does work. Thanks, Skinny
  6. I

    OMC Sea Drive Trim Will Not Hold

    I have a 1983 1.6L Sea Drive on a 1984 19ft boat. <br /><br />When applying full throttle or sustaining speeds above idling, the trim leaks down immediately causing the boat to plain incorrectly. The problem has been diagnosed as the trim/tilt valve body needing replacement.<br /><br />Does...
See more
Top