Recent content by imported_WWPerk

  1. I

    Basic Wiring Manual

    I wrote earlier about every time I turned the key I blew the 20 amp fuse near the solenoid on my 120 HP 'rude in my '83, 18' McKee craft CC. Some one suggested I check the wiring from the ignition switch. I did-what a mess! Someone went to town with the wire cutters, crimpers and splice...
  2. I

    Short in my wiring to 120HP Evenrude

    I wrote earlier about every time I turned the key I blew the 20 amp fuse near the solenoid on my 120 HP 'rude in my '83, 18' McKee craft CC. Some one suggested I check the wiring from the ignition switch. I did-what a mess! Someone went to town with the wire cutters, crimpers and splice...
  3. I

    120HP v-4 89 Evinrude blowing starter fuses

    My 120 HP E-Rude keeps blowing starter fuses (20 amp). The tilt/trim works until I turn the key. There is a 3" to 4" wire with a rectangular male connector hanging below the powerhead at the engine's fulcrum point. Is that a problem? Where does it go- I can't find where it connects?
  4. I

    No Electricity to start, raise/Lower 120HP Evinrude

    I took out my 89 120HP Evinrude on an 18' McKee Craft CC yesterday. I was trying the tilt and trim when it stopped working altogether. I shut off the motor and could not restart it due to no electrical current- like a blown fuse. It is not a battery issue. I had a fully charged back-up. Could it...
See more
Top