Correct but everything was fine before rebuilding head and for about one hour after rebuilding then just went dead and will only bust off not crank all the way
I made sure when I pulled it apart that I match all push rods and rocker to where they went.
I was finally able to do compression test
#1 130 psi
#2 130 psi
#3 140 psi
#4 130 psi
Seams little low I would think this needs to be around 145 150 ?
Also u can't adjust the fall on this motor, there is no valve Lash spin motor to top ded #1 tighten bolts down to 20 ft pounds
Then spin...
It does not have a water fuel separator on it idid check the fuel no water in it but smelled old and dark yellow tint I just put that gas in 3 week before this happen. It did burn off but not at what I think it should have I am going to get some new fuel in a can and put my pump on a small tank...
Hello I have a 192 classic wellcraft with the
MERCRUISER MODEL 165 (2 BBL.) MERCURY 224 I/L4 1987
470 4 cylinder 3.7L just rebuilt the head from blown head gasket, was lossing water and come to find out it was dumping water on #1 cylinder, replaced the intake, exashuast, head, exashuast elbow...
