Recent content by jasonsnova

  1. J

    winterizing a 2011 etec 150??

    so i have a 2011 etec 150 on my walkaround that i bought in may, it performed flawlessly all season and is now hiding in its own carport for the winter. Last trip out about a month ago i went through the entire engine fog process with out a issue, and flushed when i got home. Question is do i...
  2. J

    best fish finder for bottom fishing?

    ok i've come to realize i need to update my fish finder. My current sonar will not mark fish beyond 75-100' of water (garmin 300c). I often go cod fishing and usually end up fishing between 200-350' of water. I want a fish finder only, not a combo unit (i have a nice chartplotter). I'd like it...
  3. J

    new boat new motor what prop...???

    ok so last summer i bought a hull only 2003 fish hawk 213wa (exact same boat as a hydra sport 212wa) and now have almost all the parts to put it together, I bought a rebuilt/reman 2001 ox66 200hp saltwater yamaha for it. but i have no idea what prop to buy for it?? boat is 21' according to hydra...
  4. J

    water in oil figure this one out....!!

    ok heres the story, last summer i had the short block rebuilt on my boat (3.0) it had a cracked cylinder so it was sleeved bored .040 over new every thing ...i put it all together and ran it july-sept 1st zero problems, 3rd week of september i went to winterize and upon warming it up it started...
  5. J

    new 3.0 water in the engine....

    ok guys help me "guess" my problem so a can plan accordingly! this summer i rebuilt the 3.0 in my bayliner, i ended up sleeveing the block and boring it .040 over all new pistons ,redone rods,crank etc. after i rebuilt it in late june i ran it until sept 1st with out a single problem preformed...
  6. J

    3.0 Oil in water after sitting???????

    Ok guys help me figure this out! this spring i bebuilt the 3.0 in my boat, block sleeved,bored .040 over etc complete rebuild, anyway after the rebuild it ran perfect all summer, no issues. well last time i used it was last week of august and it has been sitting since, so last sunday i went out...
  7. J

    new 3.0 wont rev???

    ok so heres the story, my 3.0(181,4 cyl) was messed up had a knocking oise so we took it out and did a total rebuild, block sleeved, new pistons,bored .40 over, new cam & lifter etc.... we'll took it out for its intial test run saturday and it seemed to run we'll except it wouldnt rev past 4000...
  8. J

    3.0 engine noise....cant figure it out

    ok maybe someone can help me with this head scratcher..... i bought a used 3.0 (1984,2 piece rear seal) that was rebuilt with low hrs(supposedly)...i installed it and it has a noise in the engine kinda sounds in between a bearing wrap and a lifter noise,but other than that rns well, so...this...
See more
Top