My last thread died so..... I was having the seal in the clamp ring replaced on my 275. Followed all OEM manuals directions. i got it down to just the clamp ring and the gear, orings, seal etc..... Then took it to a volvo penta mechanic to have him take out the old seal and put in a new seal. He...
I figured Since my other thread isnt getting any response I would try a new one. The question I have is how in gods creation do you take off the bearing on top the steering arm inside the boat above the drive? thanks :confused:
In a previous thread I explained how no matter what i tried i could not get the Pivot pin off of my volvo penta 275. I need some guidence on trying to take the helmet off by the steering fork. [I] am trying to change the u-joint bellows and so far connot get to it due to the side holes in the...
Ok on an previous thread I was ginven by don instructions on replacing the u joint bellows. i began to look at taking off the helmet. I found that i have the type of pin in the helmet that has 2 allen head bolts. I had gotten 1/4 20 bolts to thread in the two side holes to push out the pin. I...
My 87 aq131a/275 runs like champ. It doesnt overheat even on just a hose and its nice and smooth and quiet especially since the fuel water seperator was put on. My only slight concern is a small oil drip toward the front of the motor when its running. Dont know if its from the oil pan gasket or...
Ok first can anyone tell me where I can actually find a full service manual for an aq131a/275 engine and outdrive. Don gave me a great link for the operators manual but its just not quite in depth enough. Unless someone feels like walking me through it. I want to start looking into changing the...
Hi I recently bought an 87 Bayliner 1950 with Volvo Penta Aq131a 275 outdrive. I am trying to figure out a little about this boat package. What is the difference between the closed cooling system that is on mine and a raw water cooling system? Thanks
I have a couple questions. I am currently selling my 89 bayliner capri with a 2.3 litre ford motor. I took off the hose after the water pump and found pieces of rubber in it. Im assuming its from the water pump. Is it possible the pieces got somewhere that could cause problems? If so any...
