Recent content by JBIII

  1. J

    CLEAR FUEL LINE

    Is there such a thing as GOOD CLEAR fuel line. I installed all clear vinyl fuel and vacuum line on my 84 35hp Evinrude, and in 1 year it got hard and no longer flexible and you could not see through it. I use Startron and or Sea Foam to keep the system clean and treat the alcohol. I think I...
  2. J

    HOW TO COUNT THE POLES

    1984 Rude E35ELCRR I'm getting conflicting information on how many poles this engine is. I called Faria and he told me it's 12 but I saw the following in a post here. September 6th, 2014, 05:48 AM ("According to the Teleflex Instrument Technical Reference I have, all Evinrude/Johnson motors...
  3. J

    1984 35 Hp. Evinrude lost 1000 RPM

    All of the sudden my 84 Evinrude E35ELCRR is running about 1000 RPM or 10 MPH slower than it did. It starts fine and idles and runs smooth, it just runs slow. I have checked the throttle plate and it is fully open. Plugs are new but I pulled and replaced each plug wire one at a time and it...
  4. J

    1984, 35 HP Evinrude Starter Problem

    Starter keeps running after motor starts. To keep it from running I must pull the fuse at the starter solinoid, or turn the ignition off. I rebuilt the starter a few weeks ago and I'm sure I have the solinoid wired correctly. I'll try to explane how it's wired. The solinoid has two large...
  5. J

    1984 35hp Evinrude Low Speed Miss

    Just developed a low speed miss. It seems to idle fine and runs and sounds good at WOT, but in between it skips a beat inconsistantly. Where to start??
  6. J

    Teleflex Tachometer

    I just bought an Amega series Tach for my 1984 35hp Evinrude Mod# E35ELCRR. The instructions want me to set the calibration to 1/2 the number of poles on the alternator. I can't get a straight answer to my question from anyone. How do I know how many poles it has?????? I want to re-prop my boat...
  7. J

    Teleflex Tachometer Help!!!!!!

    I just bought an Amega series Tach for my 1984 35hp Evinrude Mod# E35ELCRR. The instructions want me to set the calibration to 1/2 the number of poles on the alternator. Daa, nobody can answer my question. How do I know how many poles it has?????? Or what # do I set it to????? I want to re-prop...
See more
Top