You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
-
J
The circled bolt should be the fill level check.
-
J
I didn’t hear anything for 2 weeks but today they said it is acting up again. It only seems to happen when the boat is pushed hard. The...
-
J
They finally got the boat off the lake. I spent all morning trying to figure out how to make a connection with my fuel injection service...
-
J
HEADS UP!!!! I just learned the Harbor Freight fuel injection service kit does not have the connector needed to connect to a new BF200D...
-
J
I can’t think of anything you haven’t covered without going into the electronics of the motor. Maybe it is losing the signal to the...
-
J
Not so on all fuel injection systems. I was able to install a portable tank with a primer bulb on a Mercruiser equipped boat that had a...
-
J
I bought a harbor freight fuel injection test kit a few years ago. It is essentially a pressure gauge with adapters for nearly...
-
J
Good ideas on both but any restriction upstream of the primer bulb would cause it to collapse.
The boat had an aftermarket flowmeter...
-
J
New motor last year. 121 hours. Typical clogged fuel filter symptoms except both have been changed. Runs great for about 2 miles at full...
