jimmbo's latest activity

  • jimmbo
    jimmbo replied to the thread Forums are very slow….
    It would be a Frost Day in Hell before I will ever Pay to access these Forums. No, make that a Frozen Wasteland in Hell...
  • jimmbo
    jimmbo replied to the thread Is this the idle jet? Or?.
    Take pics of the Plugs, I would clean them instead of replacing them, then run it again to see if that was the issue
  • jimmbo
    jimmbo replied to the thread Forums are very slow….
    It would be a Shame if the Forums were lost/shutdown, as there is around 25 yrs of Info here....
  • jimmbo
    jimmbo replied to the thread 1957 Johnson 35hp short to long shaft.
    Does it have a Spark strong enough to jump a 5/16" Gap? If you use the Pull Stater for the compression Test, you will have to disable...
  • jimmbo
    jimmbo replied to the thread Forums are very slow….
    Probably being monitored by one of the Intelligence Agencies for subversive Activity....
  • jimmbo
    jimmbo replied to the thread Is this the idle jet? Or?.
    Bowl Vent/Calibrated Air Bleed
  • jimmbo
    jimmbo replied to the thread Great loop speed record attempt.
    Can't watch it, as I am Permanently Banned from Facebook
  • jimmbo
    jimmbo replied to the thread 83' 115hp Mercury, prop slip.
    Here's a couple of the pics I took of it. My cousin was driving it I used this pic for the Avatar
    • DSC_1000a.jpg
    • DSC_1002c.jpg
  • jimmbo
    jimmbo replied to the thread Best 2 stroke oil for Chrysler / Force outboards.
    We always ran OMC or Mercury TCW oils in our outboards for more than 35 yrs, never had a Engine Failure, nor did they ever have any...
  • jimmbo
    jimmbo replied to the thread 1979 80HP Mercury.
    https://www.ebay.ca/itm/396468091185?_skw=80hp+mercury+service+manual&itmmeta=01JTBM8XJ2BA78KVKWV2GTWA55&hash=item5c4f56f931:g:p4EAAOSwMp...
  • jimmbo
    jimmbo replied to the thread 1979 80HP Mercury.
    About a 6 - 7 hr drive for me. It has been 31 yrs since I was in Lethbridge. I only know one person there, she used to be a Cabinet Minister
  • jimmbo
    jimmbo replied to the thread 1979 80HP Mercury.
    First of all you went and adjusted something, what we don't know. There are several adjustments on the Linkages. Some change Spark...
  • jimmbo
    jimmbo replied to the thread 1979 80HP Mercury.
    When you adjust/set the Idle speed on these Motors, you it with either cable unhooked, or the Anchor/Adjuster out of its holder. Once...
  • jimmbo
    jimmbo replied to the thread 1979 80HP Mercury.
    Perhaps the Shift Linkage in the Motor is damaged/binding/needs Lubrication If the Throttle Cable is not hooked up, does it is shift...
  • jimmbo
    jimmbo reacted to racerone's post in the thread 1979 80HP Mercury with Like Like.
    Prop must be turned when going from neutral to reverse.
Show older items
Top