When I pull out the control handle for a fast idle, the handle seems disconnected from the throttle cable which will not move until the handle is pushed fully forward when the throttle cable moves a very small amount. This requires a little force and springs back when released. I believe that...
I have not seen anyone note this elsewhere but in casting around for a container of some kind to run our 85 HP Force I saw that the engine cover seemed to fit the bill. Turning it upside down and stuffing a sponge into the handhold and it was good to go! (Duct tape would have done a better job)...
I am resurrecting a 1988 Capri cuddy with a Force 85. I cannot get the hand control to pull out to get neutral even by inserting a screwdriver behind the spring loaded washer at the back. Any suggestions as to what is sticking and the remedy?
Appreciate any help/suggestions.
