jlh3rd's latest activity

  • J
    jlh3rd reacted to KD4UPL's post in the thread Hot water heater with Like Like.
    Are you asking about electric or gas? If gas it's probably a good idea unless your water has a lot of mineral content. If electric you...
  • J
    jlh3rd replied to the thread 18ft Boat Launch with RWD Suburban.
    That's true. I do tow/launch my 24' pontoon with my '08 extended cab, long bed, 5.3, Silverado 2WD ( Posi). I haven't been to a lot of...
  • J
    jlh3rd reacted to flashback's post in the thread Hot water heater with Like Like.
    Likely the existing 240v circuit, if existing heater is electric, will not be sufficient.
  • J
    jlh3rd replied to the thread Hot water heater.
    read up on installation costs and requirements.
  • J
    jlh3rd replied to the thread New SEI drive, need a new prop..
    by book #'s : Dropping pitch by 2 inches raises WOT rpm's by 300-400 rpm's. Then adding a blade can reduce rpm's by 100-150..200 rpm's...
  • J
    jlh3rd replied to the thread Need help finding tachometer.
    I can't tell what #of pins in your plug end. Various cables out there. Grey is a tach wire. Maybe 5 wires?...pins? so, yes, you need a...
    • IMG_5672.png
    • IMG_5673.png
    • IMG_5674.png
    • IMG_5671.png
    • IMG_5675.png
  • J
    jlh3rd replied to the thread early spring maintenance.
    I must've tightened them ok because yesterday I ran the motor and no leaks. 🙂 I also must've installed the new impeller and gaskets...
  • J
    jlh3rd replied to the thread Pushing Run-Flat tires to the limit.
    "
  • J
    jlh3rd replied to the thread Boat Cover Repair?.
    yes, It works ok. What I bought at the hardware store was just a small box so not much is in there. If I thought it did a great job I...
  • J
    jlh3rd replied to the thread Lower Unit Oil Leak.
    I just think you had some anomaly. A one time thing. Oil got spilled or something. If the engine drive shaft area is leaking, you'd...
  • J
    jlh3rd reacted to dingbat's post in the thread early spring maintenance with Like Like.
    The industry-standard for tightening NPT threads involves counting threads after tightening by hand: 1/8"– 2.0” = Tighten 1.5 to 3...
  • J
    jlh3rd replied to the thread Is my motor sitting to low?.
    point is, it's not a problem until it becomes one. There are basic starting points for rigging/propping a boat but final settings depend...
  • J
    jlh3rd replied to the thread Boat Cover Repair?.
    if you can find a shop....then find one close......then wait......then repeat when the next repair is needed. gluing the strip on the...
  • J
    jlh3rd reacted to dingbat's post in the thread Trailer tires. with Like Like.
    Just had a third set of Defender 2 on my daily (Civic) last week. Got 63k out of the last set. Put upper 50k’s on the previous two...
  • J
    jlh3rd replied to the thread Boat Cover Repair?.
    I ordered a small roll of marine canvas, white, to patch my custom pontoon cover. I use the "5200" and Goop makes a marine grade glue...
Show older items
Top