I figured that out the hard way. Good thing I was already getting a new one. I thought of Mabye trying to put some heat tape on instead of spacers. I’ll try to get creative and see what works.
So I got home from work and started with the easiest test. I cranked it up and let it run and of course it started doing the same thing so I took my air compressor and blew on the power pack and immediately it smoothed right out and ran perfect for about a minute then went rough again. Blew air...
There’s no light indication on engine or anything saying it’s limp mode I just assumed bc you can cut motor off and start right back up and runs for 15 seconds and does same thing. I’ve checked heat and did all test for fuel and the thing runs like a sewing machine for 15 minutes. I’ll try...
I have a 2000 15hp evinrude 4 stroke that I recently bought for a Jon boat. Good compression in both cylinders. Before ever starting I changed oil and changed whole water pump new thermostat lower unit oil new plugs. Went for ride and run great for 15 minutes than went into a limp mode. I...
I have a 05 90hp omc. From neutral to forward it shifts fine but when I shift to reverse back to forward it is extremely hard to shift. It shifts fine when engine is not running. I took loose cable at motor and shifts fine. Any ideas. Thanks in advanced.
