No go on tapping it out and I did not want to hit harder. 40 years its been on there. Ended up making a cut with the dremel and yanking it out with pliers. For all the trouble this water seal was, I hope that I just did not need a new 0 ring.
update.
Was able to talk to my son who is a millwright.
He told me to clean out the remaining rubber, get a socket that sits on the metallic ring, put the housing in a vice and try to tap it out. If that doesnt work give the housing cap a little heat to break any bonding that has happened with...
Hi guys.
well I managed to get the B100 running, ran good and strong and used it some on the lake. End of season when I opened the gearcase nut after to check, water is getting in. So I decided to change out the prop side O ring and Water Seal. 18 and 19 in this part list. The radial bearing...
Hi Guys - I am trying to connect a multi function tach to this 1998 Yamaha 115 hp 2 stroke engine with 703 remote control box. See picture. The two harnesses from control box and tach connect ok. Its the single wires that have me puzzled. Does Blue connect to Red ? Control Box has Green...
I am waiting for the new seal to arrive. Attached is an internet parts diagram and it shows how the seal goes in. #17 The diagram is not an exact match of the actual seal. I also attached pics showing both sides of the seal. Previous owner had installed it with the gold band up but it was not...
The exhaust housing needs to be removed to get the shift cable out so it can removed and turned upside down. The bearing looks really clean. The sides appear to be stained. Attached pic. This is how I found the water seal when I removed the water pump gaskets. It was not installed flush so I am...
Thanks for that info. I also spoke with two "Honda" dealer mechanics today. One told me to use Scotch Brite on the walls with a shop towel covering bearings with shop towel and no sealant on the New Seal. Thats the way I found it when I pulled it.
The other mechanic recommended Scotch Brite...
Hi guys
I picked up an old Honda B100s 1983 outboard, and am preparing it for spring. It had water in the lower gear case and a test showed air leaking through the top below the water pump. I have a new seal coming. Part # 91252-935-004
Have a question about how to prepare the mating surface...
Came across this Asia site when searching for a portable Yamaha outboard.
They sell new and used outboards. They also sell Honda and Suzuki.
I inquired and they want a wire transfer which is very sketchy.
Curious if anyone has had any dealings experiences with them ...
Aw ok. When looking straight at it with the motor down you're turning the lock nut and the long nut clockwise as if to tighten. That was throwing me off. But now when I think about it the rod is really coming down from above and if you look at it that way you are turning counter clockwise...
Hi Guys
Just joined I have a question about lowering the gear case to change the impeller on this motor 2002 Johnson 9.9hp 4 stroke short shaft model number J10r4st.
I understand that Suzuki built it. My son brought it home and we are going through it.
I did find a 2006 service manual online...
