Recent content by josh08

  1. J

    1990 3.0 OMC Cobra

    This is the broken stud and piece I removed from the crankshaft. Whoever installed it prior installed it backwards apparently and with the wrong stud. The piece I extracted from the crankshaft was around 1 inch.
  2. J

    1990 3.0 OMC Cobra

    I'm attaching pictures of the coupler and flywheel
  3. J

    1990 3.0 OMC Cobra

    The variance between the stud od and the hole in the coupler is .057 or just under 1/16. But the coupler does wobble some on the studs. I have noticed the studs i removed were not the correct ones. They were fine thread on the crank side and not on the nut side. I'm assuming the short threaded...
  4. J

    1990 3.0 OMC Cobra

    Unfortunately their isn't enough to weld a nut on . This was prior to me trying to remove any. I'm using the largest ez out I can at the moment, and I've even used a breaker bar on the ez out, but the whole crankshaft ends up turning with it.
  5. J

    1990 3.0 OMC Cobra

    Just recently purchased my first boat. It's a 1990 Sunbird Corsair 185. I had the muffs on and started the motor, the throttle accidentally got hit to run wide open and I quickly got it back to neutral, then the motor died and wouldn't crank. I used a multimeter and determined the slave solenoid...
See more
Top