I have dt 140 that grinds when shifting in forwards. It does not do it when shifting to reverse. I just put the foot on it. When I had the foot off my Lil brother took the bolt off the shift rod. It's the bolt with the slot that hooks the To the shift rod in the foot. I tried to put it back...
I have a 1996 pro sports ff1800 nada has it at 900lbs net weight. It has a 1999 dt 140 efi. It also has a 6" back set jackplate. it also has trim tabs. i'm not sure what all info you need to help me out. The boat had a 1996 dt 115. I puthe the prop off of that engine and put it on the 140. It is...
I just put a 1999 dt 140 on my boat. Some time the engine won't shut off by the key. I have to put the key on off. Then shake the wires that go in to the engine. I have checked the wire and they all look good. Can some one tell me what wire I need to check? Thanks for the help
I'm buying a 99 dt140 tomorrow. it does not have a lu on it. I'm going to use the foot off my 95 dt115. Will my prop work on the 140 or will it be to small? I'm not sure what size my prop is but it's a ss 4 blade.
is there any problems with the 99 efi engines? Thanks for the help
I have 1995 dt115 that rsn great till the engine locked up. I will part the engine out. Every thing is good beside the long block. If you need parts let me know what you need and what you will pay for it. Or you can call me at 352-226-1805. I will also sell the whole engine for the right price...
I have a 1995 suzuki dt115. i'm getting water in my lower cylinder. When I pull my bottom plug it has brown oil slude on it. I have changed the head gasket. the old gasket looked fine when I pulled it off. What should I check next. I have only had the engine about 4 months. it ran fine then one...
Hello
I took my boat out today and the boat ran great for about 15mins. Then it started to act like it was not running on all cylinders. I stoped and looked it over and made sure the ball had not lost prime. All looked good. I went to get back on plane and it took for ever. it would not rev...
here's the deal. I have a 1986 120hp johnson with looper carbs that is not running right. when I push in on the key to choke it the engine starts but dies. If I start it with the choke and open the throttle wide open the boat will jump right on plane and run fine. It does fine after that. I can...
I have a 1992 merc 100hp. I can grab the engine and move it around. Its not the shaft that but i'm guess it would be called the upper motor mount. do I have to take the power head off to get to this. also how much would a new one cost. thanks for any help
I have a 1992 merc 100hp every time i try to start it i got to push the key in. once it starts it runs good but when i stop and shut off the engine i got to push the key in to start it again. what should i check. is there a adjustment to fix this.
I'm looking for some light I can use for driveing at night. could i use like a fog light for a car. i have a t top to mount them on so they will be high. I just want some thing better then a hand spotlight. thanks for any help
I have a 1992 merc 100hp. the other day i took the boat out. when I hold it wot it goes to about 5100rpms then it will bog down to about 4800rpms then go back up some time it won't go past 4800rpms. what could cause this. I changed my fuel filters blew all the lines out with air. took the carbs...
i have been messing with my 1992 100.well i thought i had used alot of oil but my brother had used the boat and did not refill the oil.today i put new plugs in it and took it for a ride when i got home i pulled all the plugs. all of them had what looked like oil on them. they still looked new...
