Vail took over whistler/Blackhome a few years ago. Sun peaks is very different. Less trendy more hillbilly with excellent vertical and cold snow. whistler/Blackhome gets wet “coastal” snow. SP if you are a skier.
wet “coastal” snow.
All done, back together and running much better. Here are some FYIs for the next person looking to do this.
Pull the front (brush end BE) and back (Gear/prop end GE) halves off the center magnet (MA) area. You need to reseal both ends with an o-ring. When i pulled mine apart there was...
So where are you at? Any skiing nearby? Heading up to Sun Peaks in a week. Time to self isolate for a couple weeks then go crazy skiing.
https://www.sunpeaksresort.com/explore/sun-peaks-in-winter
ATF? not what i would have thought. I started cleaning it up and putting it together today along with adding drip spouts to the RV. Finally got too cold to be in the garage. I might get it finished tomorrow but more likely next week.
Thanks
Awesome. Or is it "you are awesome" This tells me a ton. Now i know what the coils are for and why they placed them down there. They are to create the different speeds and are in the bottom for water cooling.
Unfortunately, the quality of the picture is too pixilated and i cant read the...
There is a ton of information on mounting solar panels in the RV forums. I used super high adhesive tape called VHB to mount two panels to the top of my RV. No holes in the roof. However, you could weld a couple mounts onto your roof or bolt right through. Two other thoughts.
Can you tap...
If you have a spare battery or a 12vdc source you could hook the negative of the battery to the frame (BTW, yes you should scratch the paint off the frame where your white wires attach) then use a wire from the positive to each of the posts of the trailers wiring harness EXCEPT the ground post...
Good morning all.
As the title says I screwed up. My brother gave me a broken early 1980s Mercury Thruster plus trolling motor. Before i took the wires off the motor I took a picture but i didn't look close enough or write down the location of the wires. My problem is that I have just spent...
