Hello brim buster,
Thank you for your response to my post. The information you sent is for a single cylinder ESKA up to 7.5 HP with a solid state stator and ignition points. I do have this section of the ESKA manual. In addition, I also have the part of the manual pertaining to my issue...
I am in the process of replacing a CDI 110-958 stator in my 1973, 9.5 ESKA and the ESKA manual states to set the top cylinder to .125 BTDC. I know this is 1/8 of an inch but cannot find any " how to " information elsewhere. Finding TDC is not an issue. I have both of the tools from Tecumseh...
Good morning again brim buster,
An update !
Just found if you ask the correct question of any body or thing you likely will find the answer. I started my search on You Tube and changed my inquiry. I found a fantastic area I never knew existed. Check out on You Tube " coil and stator outboard...
Good morning brim buster,
Thank you for responding to my post. I did not note on my posting all the information one would need. My electrical system is a SSI, that is a problem because very few people have ESKA outboards with this system. It is a good system at least it has provided me with...
I am having no spark issues on my 1973 Eska 9.5 outboard and need to know how to hook up my meter to each coil. Should they be removed from the block? I know it requires checking the resistance ( ohms ) and I also need to know the correct reading for a good coil. I have owned this motor...
