So I noticed on my dash that the volt meter was reading around 8 volts. My next outing I took my volt meter and texted straight off the alternator. It was showing 22 volts. So I pulled it and took it to autozone to get it tested and of course they couldn’t figure out how to test it because I...
OK...long story short.
1996 5.7 carb motor pre vortec
I have had this boat for approx. 10 years.
Motor went bad approx. 4 yrs ago. When I took the motor apart, it all looked to be in great shape except it had burned a hole in the head between the inner cylinders and the block at the mating...
Can anyone tell me if it is possible to change the pick up hose without pulling off the bellows?
I would like to just remove the hinge pins and hopefully gain enough room to replace the pick up hose.
Any suggestions?
I fear my motor is not getting the proper water flow and I can't figure out why.
I just put in my 2nd replacement motor in three years.
My first motor burned a hole between cylinders 3 & 5 where the head meets the block.
It was a 1996 motor and I just assumed it wore out.
I replaced that motor...
