Recent content by KC9000

  1. K

    1975 25 hp Evinrude 25502B

    Well I did not put new ones on yet, but manipulated the current ones to close the best I could get them to test out. It worked, throttle valve can close and motor can keep a good idle.
  2. K

    1975 25 hp Evinrude 25502B

    Sweet will order them and update when installed
  3. K

    1975 25 hp Evinrude 25502B

    Being curious and wanting to check the reed valves. I took them out and this is what I found. I am sure this is the idle issue. As it seems like it's getting too much fuel when throttle closes to idle. Check out the pic and give me your thoughts. You can see light on those two holes and there is...
  4. K

    1975 25 hp Evinrude 25502B

    Anybody know what this paint color code is or the name of it? For the blue?
  5. K

    1975 25 hp Evinrude 25502B

    Yeah I had it set pretty good in that 2nd video. I had the idle adjustment set to the lowest I could go with out it dying. But had to have the throttle valve open a smidge to keep it going. I am gonna check vacuum leaks and carb swap and test. Got parts on order to address the baffle gasket...
  6. K

    1975 25 hp Evinrude 25502B

    Yeah I had it set pretty good in that 2nd video. I had the idle adjustment set to the lowest I could go with out it dying. But had to have the throttle valve open a smidge to keep it going. I am gonna check vacuum leaks and carb swap and test. Got parts on order to address the baffle gasket...
  7. K

    1975 25 hp Evinrude 25502B

    @Crosbyman I Will be trying that for sure when back together, I don't have the lean sneeze tho, or maybe a form of that? What's happening to this motor is when I back the throttle down to its Lowest, the engine just dies. No sneeze, just dies. Ican make it sneeze by adjusting the low speed...
  8. K

    1975 25 hp Evinrude 25502B

    Carb or intake problem? Like Reed valves?
  9. K

    1975 25 hp Evinrude 25502B

    What you thinking? Even a guess?
  10. K

    1975 25 hp Evinrude 25502B

    Well had to be done. I will swap carbs after it together and see if it's that
  11. K

    1975 25 hp Evinrude 25502B

    Would the baffle gasket leaking cause that idle issue? Or the missing drive shaft oring? Or the damaged waterpump grommet?
  12. K

    1975 25 hp Evinrude 25502B

    165738 was the way the bearing was and was correct. 165741 is the bearing.
  13. K

    1975 25 hp Evinrude 25502B

    195928 pic was facing the bearing. 155508 was facing the spring and that is fuel mix on that side of the seal. I will post pic of bearing as soon as I get home. Thanks again for you time and reply.
  14. K

    1975 25 hp Evinrude 25502B

    Bottom of lower crankshaft seal. There is a small knick in it....
  15. K

    1975 25 hp Evinrude 25502B

    Well that was easy. Clip spring and pulled the lower seal. Will update when she's all back together. Hoping for a good idle. There was some fuel on the top of the seal, so it could have been leaking. Rubber inside looked old and worn too.
See more
Top