Recent content by Kerpit

  1. K

    What Wood For Lund Tyee Interior Rebuild

    Hi There I am seeking help on what type of wood to use to rebuild the interior helm station, port station and side panels with on an 85 lund tyee 5.5. The helm station and port stations were rebuilt with interior birch veneer coated with spar varnish years ago that did not last. We are re...
  2. K

    85 evinrude looper idle timing

    I have a question regarding an 85 evinrude 140 looper e140tlco. I have an oem manual and i couldn't find any idle timing specs. I have the wot timing set at 22 degrees. But i was having a high idle and i found an intake manifold air leak. It was idling at 2000 rpm at 2 degrees btdc idle timing...
  3. K

    Bravo One Engine Coupler Question

    Hi There I am seeking some assistance with my 06 bravo one/350 mag mpi engine coupler. I had the aluminum coupler strip the splines a few years ago. At the time i didn't know of the common failure so i replaced it with another aluminum coupler. I did not check the engine alignment at that time...
  4. K

    Pre Alpha Remote Control Upgrade

    Hi There I am looking to upgrade the remote control in a 1977 four winns with a 165 pre alpha. What would it take to install something newer like a commander 3000? The only thing i really don't want to do is change the lower shift cable again. Due to the trim system and how it prevents the...
  5. K

    85 140 won't stay running in gear

    Well i have an 85 evinrude 140 that recently has a new power pack and regulator and diconnected the vro so i mix the gas in the tank now. Well it runs great but has a little bit of a problem idling like it's too low in neutral but will die if i just put it in gear and putz around or go to...
See more
Top