GOOD NEWS. . . . The PICTURE UPLOAD FUNCTION IS WORKING !!! The tech folks at the parent company have been able to remedy the issue. You can upload pictures once again. Thank you for your patience.
I need to replace the transom on a '75 Crestliner.(see photo). I have a few challenges to overcome in order to replace it and need some opinions. The transom fits in behind the splash well on the inside (see yellow arrow). I can't just tilt the new transom into place because of the support...
I'm rebuilding the stringers and transom in a fiberglass '75 Crestliner. After removing the stringers, I noticed water coming out from the center of the boat and under a layer of 1708. After some sanding, I found a 2" piece of wood about 9' long running from the bow to the transom that was...
I have to replace the rotted stringers and floor on a '75 Crestliner Apollo and need a little advice. After removing the stringers, I still have the fiberglass mat that was used for tabbing attached to the hull. Do I need to completely remove the old fiberglass tabbing or can I grind it down a...
Took the boat out and it wouldn't run above an idle. Any throttle movement caused the motor to stall. I took it home and found that I'm not getting spark on cyclinder #1 but 2&3 had spark. I switched plugs and wires and had the same problem. I, then switched the orange coil wires on #1 and...
Hi all, my tilt/trim motor doesn't work all the time. I think the motor is bad because if I tap it with a hammer it'll start working. However, for my question, when testing the voltage I noticed that I get 12V on the blue and green wires regardless of whether I'm pushing the up or down button...
Hi all, my tilt/trim motor doesn't work all the time. I think the motor is bad because if I tap it with a hammer it'll start working. However, for my question, when testing the voltage I noticed that I get 12V on the blue and green wires regardless of whether I'm pushing the up or down button...
