Recent content by kevinpouliot

  1. K

    1996 evinrude 50 hp

    Fuel pump not sure of its age i would like to rebuild this as a new one from the local dealer is about 258.00 is there a rebuild kit for this. this has the oil inection on this particular motor and is working fine.<br /><br /><br />dude
  2. K

    1995 evinrude choke selonoid

    Which position is auto on these units all the way clockwise or counter clockwise?<br /><br />Also if the choke was set to manual mode with this help prvent my primer bulb to stay rock hard i figured if it were in mannual it would possibly bleed off the prime eventually at my bulb,<br /><br />thanks
  3. K

    1995 evinrude 50 hp oil injected just shut off is there a fuel cutoff

    Ok befor eyou guys say this the manual is on order. I was out today boat ran great all day parked in a cove for a while started motor it ran ok for about 20 seconds and then shut off. Would not restart at all. I tried for over an hour with my luck nothign and my seculded fishing hole was so...
  4. K

    1995 Evinrude 50 hp oil tank

    I have just pruchased this everything seems to run fine i was at the lake this past sunday and everything ran good i did get the oil alarm twice at different times one chrip every 40 seconds this sounded twice on both occasions. I was told by a friend that could of been air since i just filled...
  5. K

    trim/tilt guage wiring on 1995 evinrude 50 hp

    I am thinking about adding this guage and need to know if it will even work with this engine. Is there certain wires i just need to tie into or is there another piece of eqipment that i need in order to get this to work please help<br /><br /><br />regards<br /><br />toondude
  6. K

    Trailer brakes

    I have a 25 foot crest III pontoon boat with a MTI trailer dual axel. Is it possible to add brakes to this and if so is it a do it yourselfer kinda thing and possible a cost range or where i might can find the items needed.<br /><br /><br />Best Regards
  7. K

    1995 evenrude 50 hp

    I am wanting to add a trim guarge on this motor. Is this even possible for this year and model the motor has oil injection in case that helps and if i can add that how do i go about doing so. If the motor doesnt come ready for that then are there any aftermarket parts i can use to get this working.
  8. K

    50 hp evenrude 1995

    Just bought 1995 crest III pontoon with evenrude 50 hp everything works great. I had a bass boat before big difference in boat ride but not sure of this as i never had this prob before with my bass boat. The boat seems to pull to the right is that standard with a samller hp outboard or is it the...
Top