1986 4.3l engine. motor will get up to around 3k rpm and it will go no higher. The motor will actually back itself down. If I let it sit for a few minutes it will do the same thing. I have gone through most of the usual attempts to remedy situation and everything I try results in the same...
I converted my 1986 4.3l OMC cobra to the Delco Voyager electronic ignition. My question is: with the Delco Voyager system is the ESA module still used? According to the included instructions, the ESA unit is no longer used. I cannot get an answer from CDI or Delco regarding this. I just had...
I am starting the process of repairing the stringers in my 1986 Renken. Tapping on the stringers, the wood sounds bad in a couple of places and the engine lag bolts pulled out. I am thinking about repairing them either with the Rot Doctor chemical way or opening the tops and replacing the...
I am not sure if I am doing this right but I would like to get some advice. I have a 2001 GM 4.3l I/O. I am going to replace the flywheel. Is there any way I can tell if this is a two piece flywheel(ring gear)? Part number gm3 14091599n. Thanks
