i have a 1986 hydra sports tunnel hull bass boat 17.5 foot . i had been running a merc 150 xr4 black max, but recently after the merc shot its wod. ive purchased a 98 evinrude ocean pro 150 ficht . being an ocean pro with the 25 inch shaft a jackplate was a must so i found a used plate for...
i have a 1988' mercury 150 blackmax xr4<br />my tach quit working <br />yes my control has the plug<br />there is a black (ground) purple (ignition)and gray wire the gray wire is connected to the back of the tach also with the word "send" above it i assume sending unit ?<br />...
today while taking the family out boating we i was in the water waiting to get pulled on a tube but buddy couldnt keep the motor running long enough to get it in gear because of needed carb work<br /> so being the intelligent one i got behind the wheel and started the motor i had the rev up up...
my rpm gauge quit working a couple of weeks ago<br />recently going down the lake i fumbled around under the dash and it started working again for that day it hasent worked since<br /><br />i just went out there with the test light <br />with the key on im getting power to 2 posts on the back of...
have a couple questions.1988 150 mercury xr4 has hard time idling recently started just dying . loads up bad i changed plugs but didnt help it . the motor is on a 1986'hydrosports 18ft tunnel hull would like to get more top end out of setup any suggestions i cant afford a jackplate <br />would...
