What is the general consensus on this topic? I am rebuilding some parts on my boat seats, mainly the seat base frames and a couple of the seat bottoms need new plywood. I also plan to make a small 36" jump seat in the back. When I build the new wood I am thinking they would be best if...
Thanks, guys... I have a local guy that might be able to do it. I was also looking at a standard bimini top frame and I think that if the top could be shortened down enough, a new canvas could be made using that frame design and would help a canvas shop if they didn't work with the tubing.
I...
Hi all, I have been looking for somebody that sells a bimini top which would connect to my windshield on my 1967 Hydrodyne and cover about 6-feet behind the windshield. I would like it higher than the windshield, but not sky-high like a bimini top seems to sit.
Any thoughts?
Something like...
Hello, I noticed in a post you shared some photos of a grease tool made from an old gimble bearing race. If I am seeing this correctly, you are pulling the center bearing out of the new bearing assembly, and greasing it with the shop-made tool, correct? How often do you pull the center-bearing...
Hi guys, I am curious about the best way to go with my 1967 Hydrodyne. My MC 1 outdrive does not have the provisions for a grease fitting. (There's no hole, passageway, or fitting leading to the bearing race) Looking at the bearing that came with my kit, it's a greasable bearing. However...
