OMC 1986 4.6 , Not cobra. Tilt works fine when its not running , but when I run it for a couple hours the Tilt will not go up. I can here the trim doing something but seems to go down a little. When I rested the motor for about 20 minutes the tilt worked again with no issues. Solenoid or...
http://eauclaire.craigslist.org/bar/1736368934.html
Thinking about buying this boat package. Whats the Chrysler boat all about? Never new they made one.
Price?
I put a new solenoid on my 1987 85hp Force and the black ground wire was frayed, so I was going to replace it. while unscrewing it from my terminal post the head on the screw broke!! so I just wired it to the ground on the the rectifier. It started up fine, as long as its a ground I should...
Need a new starter (1987 85 hp) I see there are a lot on ebay. Prices vary from $79 new to $200 new, of course I like the lower price. Any experience's or info would be great.
Thanks
will a 1987 85hp lower unit fit a 1988 125hp lower unit? both are 20 inch.
The lower unit of the 1988 125hp has no prop and no splines. My 1987 force 85hp, the reverse gear is out and I was hoping I can just add the splines and prop from my old one ?
Hello eBayer
1987 force 85hp
for $130 i rebuild the valve body which probably fixes it.
for $160 i send you valve body and you send yours back after
swapping it out. Core deposit required.
for $200 i rebuild your motor and valve body
for $260 i send you rebuilt motor/valve body and you...
1987 force 85hp
How do you know if the impeller is not working or starting to go. Would water still come out the pee holes and exhaust if not working? The reason for the question is I thought I saw some steam coming from my exhaust but still has water coming from both outlets. And where is...
1987 force 85 hp. Found a small 1/2 inch crack in lower unit by the exhaust. There is bolt located inside the exhaust, it looks like somebody over tighten and cracked it around the bolt area. There appears to be no water concern getting into the lower unit itself because the crack is inside...
1987 force 85 hp. Runs great forward, but while engaging into reverse it make this grinding noise? but will eventually will go into reverse if I engage it quickly
1987 force 85hp I have a bad valve body on my power trim/tilt. Trying to figure out if is the 2 wire or 3 wire setup
I have 3 wires coming from power tilt motor green and blue and black
Would the black just be a ground ? and they only consider the green and blue just the 2 wire setup...
1987 force 85hp. Broke my remote control today ( only runs the throttle, forward and reverse) while advancing it to full throttle this piece of plastic broke and could not get it back to neutral. Had to shut off engine and get towed back. Are these easy to get. My tilt and trim are not on...
Ok, Bad day on the lake. I bought this Glastron boat with a 85hp force. about 3 weeks ago( I have not taken it out yet, 1st time today). well about a week ago I found out the 2nd cylinder was not firing. Fixed that problem ( bad CDM (I) ).
Today I brought my family on this lake...
1987 force 85hp.......Tried everything, heat, impact tool, etc....... For now I used a pump and got most of it out. The color was a mixture of dark green (about 80%) and the rest was a normal green/emerald color....but no milkish stuff? Will probably have to drill it out at the end of the...
