Hi all, Hope you can help. I have just imported a Four Winns 180 from the USA to he Middle East. On putting the boat in the water for the first time I was a concerned about e oil pressure reading. On the VDO dash there are no psi readings but the pressure is indicating the 3/4 mark at idle and...
Hi Everyone,
Looking for some assistance.
I have an old Yamaha 200 V6 on my old boat.
Unfortunately I have not been able to use the boat over the last few months.
I had the hydraulic end caps replaced in April and the hydraulic unit check and and it looked good.
Since June though I have been...
Hi there,
New boat owner and have an old 19ft with Yamaha 200HP V6.
I have just had the tilt trim repaired as fluid was leaking from one of the end cap seals.
This was done approx 3mths ago, fluid was flushed and checked and everything worked great.
Unfortunately I then had to go away so the...
Hi there guys and girls,
Reasonably new to to Boating and I have a problem with the tilt on my Yamaha 200 outboard.
My boat is an old Gulf Craft (being in the Middle East) and it has on it a Yamaha 200 V6.
I've just been out all day with the boat without any problems and raised the engine...
