Recent content by LRCXed

  1. LRCXed

    Proper prop help.

    Re: Proper prop help. As you can see the OEM hub fits fine in the back of the new prop. Will this be ok to run this way?
  2. LRCXed

    Proper prop help.

    Re: Proper prop help. The thrust washer that came with the new prop is way to thin to use by itself. With the OEM spacer it seems to fit fine. But with the added brass spacer it's held out to far. I have tightened down the nut and it didn't make any difference. I THINK it would be fine with...
  3. LRCXed

    Proper prop help.

    I have a 1970 Glasspar 16' Citation with a 120. The Mercruiser IO is vin # 2550333. Engine ID is 3937746 I bought a new style Quicksilver prop with the replaceable center hub. When I install it the way the directions say to, the prop is held out to far and there is a gap between the housing and...
  4. LRCXed

    Need help with tilt pump please.

    Re: Need help with tilt pump please. Thanks Don. I had asked about the ATF, so I just picked one. I'll flush it out again and use Dexron since I have it apart again. With your noticing the spring I pulled the check ball/piston apart. Only 1 of the four fell out easily. I had to push the other...
  5. LRCXed

    Need help with tilt pump please.

    Re: Need help with tilt pump please. Here's the pump (already pulled) and the switch I would like to rebuild. BTW, the engine # I wrote in my book years ago is 3937747 if that would help identify the year.
  6. LRCXed

    Need help with tilt pump please.

    Hello everyone, I've looked around the forum all morning and don't see the answer I need. I have what I think is a 70 or so Glasspar 16' Citation w/120 Mercruiser IO. I completely restored the entire boat from the stringer up as well as rebuilding the motor and electrical system about 13 years...
See more
Top