Recent content by lummer

  1. L

    1991 350 boca grande- Electrical issue

    Does anyone know where I could locate some electrical schematics. I have to figure out why I have no power to one of the AC units. I cannot locate any breaker/fuse panels. Any help would be appreciated. Thanks
  2. L

    Flooding 1995 johnson

    1995 j30eleob- My started went so I replaced it and now for some reason I can't get it to idle and its hard to engage the throttle because at low rpm it will flood itself. I checked the carb, float etc seems to be operating, I closed the valve on the primer thinking that may be the issue. I have...
  3. L

    Replacing lower unit to power head gasket

    I have a 1995 30 hp johnson j30ELEOB I took it out this weekend and had exhaust and some water coming into the cowl which I found out the because it was being sucked into the carb and stalling it out, I assume from what I saw that the its the gasket that connects the power head to the lower unit...
  4. L

    1999 Merc 225 efi

    I took the motor in and had the marine mechanic scan it and they said that at higer rmp cylinder #4 isn't getting enough fuel and shuts down. Compression is good. I took all the injectors off and took them to be tested and cleaned and they all run properly. What could possible cause this? Also...
  5. L

    what effect does a worn impellar have?

    What possible problems would there be if an impellar was bad, My motor is running badly. When I was out last I found that if pulled the choke out a bit it did improve how it ran but it still needed to be primed to run. Even still it stalled and acted up alot. I am trying to get to the botom of...
  6. L

    1987 15 hp johnson stalling J15RCUD

    I have to manually prime it to keep it running but it still runs high then low. I changed the gas tank and have a new line on it but still does it. If I don't prime it it will simply stall out. Any suggestions? Johnson Model 1987 J15RCUD
See more
Top