hi i have a furuno 1900 with a open array, system works and array goes around but doesnt recieve signal i notice that theres three wires cut from when it was remove and i believe those are for the signal does anyone have a diagram for this for if csomeone can tell me where to hook up those 3...
hi im looking into purchaseing a tamd 70c for my bost the one i found has 9500hrs on it can some one tell me how many hours are these volvo diesels able to run up to
hi i need to know what size prop with what pitch is needed for this motor with 280 outdrive i have the motor in a 2000 seaswirl stripper 2600 and i gett the motor wot at 3000 rpms but cant get the boat to plain out please let me know thanks
hi i just had a tamd40 installed in my boat but the guy that instaleed it did a terrible job now i went to go try it out on the bay and it doesnt rev up more than 1700 rmps and i had to hook up an electric fuel pump to the mechanical fuel pump because with only the mechanical one it would die...
hi can any one tell me what degree thermostat i need for this motor because i have 2 different manuals for this motor and one says that the standard is 140 and the other says 160 but i put a 160 on my motor and the gauge says 3/4 hot and ive changed everything on it water pump raw water pump...
i have a 1990 omc 5.7 and i have already had the heads rebuilt put in a new thermostat changed the temp sensor and impellor and waterpump for the motor and after it warms up im getting a reading on my gauge of 3/4 hot at idle and it does not move from there can any one tell me what this can be...
hi i have a 1990 johnson 100hp commercial vro outboard and the past two times i have gone out with it its been giving me problems it starts up fine idles good takes off with no problems but when i fully accelerate it it runs good for about 2 mins then it slows down for acouple of mins then picks...
