I have a removable clamp-on seat base that I use on one of my jon boats. It looks similar to one pictured here. <br />The problem I have is that the thing slips off the bench or slides around too much. But on one of my boats I have some brackets screwed to the bench that hold it in place...
Does anyone know where I can order an OEM manual for a '92 Force 120? I looked at Ken Cook's website but it seems they only have OMC books (I haven't call them yet) so they don't look hopefull. I don't think the Seloc and Clymer manuals are specific enough for me. - Thanks.
Do Evinrude/Johnson motors have accelerator pumps on them like Mercury's do?<br /><br />What fuel component on an '89 Evinrude 150XP (E150STLCEM) compensates the carb jets with a shot of fuel when the lean condition from accelerating off idle is created?<br /><br />In other words... When the...
Is there a way to test the choke solenoid that sits on the side of the motor? Likewise, is there a rebuild kit available or does the whole thing need to be replaced?
I've read many places (including here) that the boat should be stored winters with full fuel tanks to prevent condensation. However, I have also read that re-formulated fuel with ethonol should not be stored more than 60 days. Whats the scoop?
I've read many places (including here) that the boat should be stored winters with full fuel tanks to prevent condensation. However, I have also read that re-formulated fuel with ethonol should not be stored more than 60 days. Whats the scoop?
I have a 1989 Evinrude 150XP that starts cold and runs fine until it is shut off and restarted. I can idle, race WOT, or cruise from a cold start through high temp; but when I shut it off for just a few seconds and restart, it loses power and dies as I increase throtle while in gear only but if...
What is the compression supposed to be on a 1989 Evinrude 150 XP (E150STL)? I did a compression test (without warming the engine first) and all port side cylinders were 90 and starboard was 100. Just thinking about this now, I probably should have warmed the engine first, but I'll do it again...
In which order are the cylinders numbered on a 1989 Evinrude 150 XP (E150STL)? Which is number one (port or starboard) and are all the odd on the same side and even on the other?
I have a 1989 Evinrude 150XP that starts cold and runs fine until it's shut off and restarted. I can idle, race WOT, or cruise from a cold start but when I shut it off for just a few minutes, it loses power and dies as I increase throtle while in gear only but if I fiddle with the throtle stick...
I just bought the boat a couple of weeks ago... It had an inoperable fuel guage and tachometer but i thought "I can fix that!" So here I am, the fuel sender floats were saturated, now fixed. The tach however has me stumpped. The first time on the water I noticed the volt guage rise near 18v on...
