Recent content by maggun

  1. M

    Johnson 50 '84, easy question

    Trying to remove the engine block.<br /><br />First off, my Seloc manual does not describe how to remove the engine block, or give any indication on how it is fitted, no technical diagrams or anything. To quote the book it says "We assume you have managed to remove the engine block". And of...
  2. M

    Johnson 50 '84, engine block removal

    Johnson 50 '84, Mod. nr. J50BELCRM<br /><br />Im having slight difficulties removing the block.<br /><br />I have unscrewed all the bolts that I think is relevant, that is 8 bolts on each side, and there were also 3 smaller bolts/nuts on the back of the engine that I removed. However, one of the...
  3. M

    Engine block removal

    Johnson 50 '84, Mod. nr. J50BELCRM<br /><br />I am in the situation where I will have to remove the engine block to inspect and likely replace piston rings. I have the service book for the engine, however, I can not seem to find any information or schematics on how to remove the block. What...
  4. M

    Really wierd issue, Johnson '84

    Johnson 50 '84, Mod. nr. J50BELCRM<br /><br />We have had some earlier issues with the ignition, spark was bad on cyl nr 1, which was fixed after replacing the power pack.<br /><br />What is left is an engine that still runs rough on idle, it revs up, and occasionally drops down almost to a...
  5. M

    '84 Johnson 50 hp, Need advice

    Nr 1 cylinder fires with piston in top and bottom position, nr 2 fires normal i.e. in top position.<br /><br />Im thinking it's the power pack, can anyone comment on that ?
  6. M

    Seldom ignition issue, '84 Johnson 50 hp

    Johnson 1984 50 hp, 2 stroke, 2 cylinder.<br /><br />We have for some period had performance problems with our engine. Which made me go through anything I can think of, including carbs etc. Symptoms: If i remove the top spark plug lead, leaving the engine running on cylinder nr 2. (bottom), it...
  7. M

    Johnson 50 '84, High rpm problems

    Hello fellow boatsmen<br /><br />Johnson 50 '84, Mod. nr. J50BELCRM<br /><br />In coldstart engine starts easily, but it stops shortly after, requiring several attempts with choke on/off 5-7 times before it is able to keep running. Operating in the water, there is a threshold to how much...
  8. M

    Johnson 50 '84, Video provided

    Hello fellow boatsmen,<br /><br />Johnson 50 '84, Mod. nr. J50BELCRM<br /><br />Introduction: <br /><br />We are experiencing various difficulties and anamolies with this engine, all probably related to a single mechanical/electrical problem. I will try to explain what these are and provide...
  9. M

    Help !! Johnson 50 '84

    We have a Johnson 50 hp 1984 mod.<br /><br />Mod. nr. J50BELCRM<br /><br />We have problems with running this engine at high rpm's, if I try to give throttle, it just dies suddenly. This happens, even though we have let it run for at least 10 min., letting it get warm.<br /><br />I have tried to...
  10. M

    Johnson 50

    We have a Johnson 50 outboard engine wich has recently started to make a constant sirene/beeping sound when running in idle. No sound occurs in speed, and also dissapears if it made noise when in idle. There is a steady stream of water wich isn't very hot, about body temperature. The engine...
See more
Top