Recent content by Mapet

  1. M

    Evinrude 35hp +/-1980 missfire at higher rpm (lower cylinder)?

    Thanks. Quick update - I had to take powerhead off to have better access (one bolt in exhaust plate broke and stuck) and to torque everithing up after repair. I have done it to take a look into exhaust itself and investigate from where this wite stuff which I mentioned in the first post is...
  2. M

    Evinrude 35hp +/-1980 missfire at higher rpm (lower cylinder)?

    Thank you, I finally got ordered parts :) I have new head gasket, two exhaust cover gaskets, rebuilding set for fuel pump and carb. I will make some pictures from repair and post here to keep you updated. I will also write something after checking engine on the water. Regards
  3. M

    Evinrude 35hp +/-1980 missfire at higher rpm (lower cylinder)?

    Thank you all for answers :) I will do as you advised - plan/flatten head and change all gaskets to the new ones. I will take a look into carb again to check if there is a gasket mentioned above. Could you advise what torque I should apply to the bolts on the head and which order? Same...
  4. M

    Evinrude 35hp +/-1980 missfire at higher rpm (lower cylinder)?

    Yes, I can see exhaust fumes going out from TT but only a few seconds after starting engine and good continous stream after. It is a good news for me that head doesn`t look good for you :) I`m not mechanic and it is my first project on the outboard engine - as metal rings were fine I would...
  5. M

    Evinrude 35hp +/-1980 missfire at higher rpm (lower cylinder)?

    I`ve got good water flow from TT all the time, thermostat works as it temperature is cold - warm - cold- warm etc. Steam which I`m talking about is getting out from two holes on the leg sometimes - i.e. when I stop after going for a while. I have done link and sync by setting up carb - low rev...
  6. M

    Evinrude 35hp +/-1980 missfire at higher rpm (lower cylinder)?

    Hi, thank you for reply. As mentioned in the post I`ve checked the compression and was good on both cylinders (125 and 123psi if I remember correctly). Not sure what "TT" means. I have changed exhaust gasket between block and leg as it was blown out. Head gasket I checked two days ago and it was...
  7. M

    Evinrude 35hp +/-1980 missfire at higher rpm (lower cylinder)?

    Hi All, I'm new on the forum but been reading it for a long time - it helped me a lot but now I need to ask for advice as I have enough and don't know what to do. Short story: I have bought old evinrude with several issues (I was thinking that engine is quite ok) and managed to get rid of...
See more
Top