GOOD NEWS. . . . The PICTURE UPLOAD FUNCTION IS WORKING !!! The tech folks at the parent company have been able to remedy the issue. You can upload pictures once again. Thank you for your patience.
Checked the voltage and sending wires all good. So I drilled a small hole on the side used a coat hanger to move the needle. It was really stiff but about after a few min of working it around it was nice and loose. Hooked it back up abd it works. Sticky needle.
Thanks for the help.
Hi. Thanks for the reply. So I went out an looked for it and found a cluster of wires with a purple, grey, brown, and black. The harness has 4 connectors. One was going to the fuel gauge and the other 3 were not hooked up. The end of the connector of all three would fit my rpm gauge. Here is a...
I recently bought a 2005 Smoker Craft with a 50hp Mercury outboard. Runs great. However the rpm gauge is not connected. I see several wire harnesses in the back (3 look like the same connector) but I’m not sure which one it is. Any thoughts?
