Recent content by mclamore

  1. M

    yamaha 2000 175 hp ign. timing

    Att: Rod Bolt After re-building for broken piston and rings. I checked the TDC as per manual with dial guage,it was correct. When I went to the full advance check this became a little fuzzy. The book said after finding TDC with the dial gauge to set it to zero. then it says to turn flywheel...
  2. M

    2000 yamaha 175 con. rods & crank wear

    I had to tear it down to re-sleeve one cylinder due to a cracked piston and broken ring. While inspecting the rods crankshaft bearings ect. I found that the bottom rod and the third one up had wear on the top sides and also the crankshaft had wear from the rods. None of the other rods or crank...
Top