Recent content by mieyk

  1. M

    Honda BF35 will not plane out unless choked

    I have a 92' bf 35 that has a fuel problem. When on the water it will not throttle up past 3k rpm unless it is choked. I cleaned all three carbs and replaced the jet sets and o-rings but still have the same issue. I did, however narrow it down to mostly the top carb. While It was idling with a...
  2. M

    I need a cdi unit for a 35/45/50 honda bf

    Did all the testing and I've a bad CDI module. If anyone on here has a good used one I would like to take it off your hands. The part number is 30580-zv5-003 and is printed on the front of the module.
  3. M

    How do I test an exciter coil? Honda bf35-50

    My motor has no spark after using engine degreaser on it. It is not the kill circuit and it is not the controls. I tested the pulser coil output with a dva and they are all within range, I tested the charge coil and they are within range but there is no test in my manual for the exciter coil. I...
  4. M

    Honda bf35 no spark

    This all started when I degreased my powerhead. I tried not to get any water or anything in the electronics but i figured wtf... it spends its life in water. It was running fine until I cleaned it. This is where I'm at... -checked for spark with a spark tester and...my finger. -disconnected...
  5. M

    Help! Trim And Tilt Stopped Working.

    The motor is getting voltage 12.5v in up and down and you can hear it making noise but not the usual up or down noise. It is very quiet and if you hold the up or down button for a few seconds it will start making the right sound and move a little (like an inch) but fade out kind of like the...
  6. M

    Lost power on top end...1989 johnson 140 looper

    I was on the water cruising at near full throttle when the boat instantly slowed down from about 30mph to 25. If I keep it around 3000rpm it will sometimes "jump" back up and have the power again but will lose it by instantly dropping as I increase rpm...its almost like a miss but it stays as...
  7. M

    johnson 115 low compression

    heres the story... i bought the motor from this guy that said it ran great 2 years ago when he upsized to a new motor. been sitting ever since in his garage. installed it on my boat, checked compression and all but one had 120 psi. the low one had 90. i havnt tried starting it yet but when i...
  8. M

    1990 evinrude 140 spark only in one cyl.

    -all 4 coils tested ok. -replaced bad timer base. the new one checks out fine. lowest reading on the 5 pin connector reads 1.4 and the highest is 1.5 on the dva. no conductors are grounded. -replaced power pack. -charge coil checks out fine at 220v. not grounded out. what else could it be? i...
See more
Top