Recent content by Milo1105

  1. M

    Prop bearing cage

    And hex nut up top and nut inside casing behind propeller to separate lower unit ? Like to see above the gears ?
  2. M

    Prop bearing cage

    And is there any special alignment when re installing the gears
  3. M

    Prop bearing cage

    Last question in order to get the guts out of the gear case (all the gears ) so I remove the bolt inside the cone behind prop and the nut on top near water pump ? And everything slides out ?
  4. M

    Prop bearing cage

    Also the hex nut on top next to the control shaft is I remove the nut and pry old o ring out would it hurt anything as long as I put a new o ring in because mines leaking
  5. M

    Prop bearing cage

    Everyone talks about how a pain it is to remove that pivot pin and a pain to get it back together makes me nervous as hell lol
  6. M

    Prop bearing cage

    Ok how about the screw on back of housing in between the gear oil fill and drain hole screw
  7. M

    Prop bearing cage

    How about the forbidden screw on the back on the gear housing ? I have a leaking seal I was told never to pull it , also how do I remove the gears inside gear case ? Is it got to do with the nut behind bearing cage ?
  8. M

    Prop bearing cage

    Sorry 1990 force 50 hp
  9. M

    Prop bearing cage

    I bought a lower unit seal kit and there’s a few I’m unsure of how to install , my seal to the hex nut and thread by control rod is leaking and needs replaced , the forbidden screw on lower needs replaced, where does the orange and yellow and very small black o ring go to ? And the larger o ring...
  10. M

    Prop bearing cage

  11. M

    Prop bearing cage

    Where can I find this part ? Mines toast I do believe, I think it’s the prop bearing cage, also how do I install the new seal I got, the forbidden screw on lower unit that connects to control rod
  12. M

    Possible metal piece in gear housing

    Hey I was trying to pry control shaft seal out and my lunch tip broke off and I’m unsure if it fell in, I have spun gears and don’t feel any binding , any tips ? Was told never to remove screw on back and I think I have to to gut gears
  13. M

    1990 spectrum blue fin 50hp force control cables

    Do you think these blue ones will work? There 12 footers and I measured my red ones and they are 12 foot end to end
  14. M

    1990 spectrum blue fin 50hp force control cables

  15. M

    1990 spectrum blue fin 50hp force control cables

    I need a recommendation on where to find two control cables that match these or would work, and how hard is tuning and hooking these suckers up , thanks in advance
See more
Top