When hooking up a Guest battery switch which has an off, battery 1, both, battery 2 setting. Should both negative wires on batteries be tied together?<br /><br />Thanks in advance
I have a 1996 yamaha 150 and recently replaced the cylinder head gaskets and water cover jacket gaskets. I always have this white salt deposit show up on outside of the gaskets after boating, it is on all areas of new gaskets. I do not see any sign of water leaking from cylinder head or water...
Can anyone tell me how the heck to get the impeller key out the the keyhole. It is really stuck in there good. I have put penetrating oil on it and took a chisel to it trying to knock it out with no luck. I don't want to hit it too hard on the driveshaft for fear of damaging gears in lower...
My 96 yamaha 150 picked up some sand today and my pee hole kept clogging up with sand and small shells. Everytime I went over idle it would clog again and the overheat alarm would go off. I ran clean water through it at home and it had a good hard stream. I also took out the thermostats and...
I have a 24 volt motorguide trolling motor that came with my boat. The circuit board has been removed and all wires have been rewired into toggle switches. One switch is on/off and the other changes the direction of the motor. There is a green and blue wire that are not connected to anything...
My trailer lights are connected to my Ford Explorer using a hoppy kit. All is connected correctly and grounded.When I hit my brakes the lights work but when I turn on my headlights the brake light will not work on the trailer driver side only, it goes off. The same light will not come on when I...
