IAC valve was cleaned and it seems to be moving. I didn’t monitor the pressure while the motor was running but it has the pressure called for in the manual. I’ll check the barometric pressure, I didn’t compare the reading. I have gone over the other electronic devices and seem to be inspec.
Do...
Hello all, I have 2018 Suzuki 115 HP that was rebuilt after it was sunk.
The motor now starts but then dies. I can keep it running if I open the throttle but it will eventually die also. I’m not getting any codes with the SDS software connected so I have no direction.
Does anyone have any...
I’m looking at a project motor and found a 2008 Suzuki 115 four stroke that runs but has lots of water in the oil. Two of the pistons has ruffly 180 psi but the other two barely break 80 psi. The asking price is 2000. Is this motor worth spending time and money or should I look for something else?
I have a used 2001 evinrude 150 that needs new Deutsch 6 pin plugs. I have the new plugs to install but i haven’t been able to find a diagram with the pin layout. Does anyone know what color goes to what PIN number?
Does anyone know if these fuel pumps can repaired/ rebuilt or do I have to purchase a new one?
i was told that it had low pressure and it was removed from the motor but I do have out.
It’s Carter 5004428 and the motor is a 2001 Evinrude 150 hp
