I am rebuilding all 4 hubs. I have Reliable torsion axles with sure lube hubs and drum brakes.
I managed to find the correct bearings, the trailer parts dealer gave me a kit with the bearings and a double lip seal.
The question I have is the original seal is transcom and is fully rubber...
I have a water leak, replaced the drain/ fill screw washers still have a leak.
I took it out for about 45 min total run time gearcase oil is milky and cloudy. I would like to pressure test it.
In the Clymers shop manual in the instructions for pressure testing it says NOTE: On some models...
First Id like to say hi. I have a 2000 9.9 4 stroke 25" shaft. engine oil changed at last winterization crank case oil changed a few running hours before that during a repair of the lower unit. The boat sat for 3 years in storage. It was put into service a few weeks ago after checking the engine...
