Recent content by moeMC

  1. M

    seats

    next job , old 1980 renken , seat vinle in great shape but wood backing wet , weak , moldy . need to replace just backing , don't want to use any plastics (starboard) stuff . any suggestines on what type of plywood , and what , if anything to coat it with ?? hope fully foam will dry out over...
  2. M

    new dash panel ??

    I need to replace my dash panel , cheap plastic holding tach., fuel, oil psi ,ammeter. was going to do it in teak . very expensive , leaning more towards using King starboard . has anyone trid it ? done a bit of reading I know to alow for expansion n contraction . any other suggestions ??
  3. M

    patching screw holes

    will be replacing carpeting in the off season ..is there a product to fill screww holes from the old seats, in the fiberglass floor before in stalling the new carpet ??
  4. M

    omc transom seal

    hello al ,new to this forum ,posted a quetion on another forum only got one reply...wanted more input if possible. "1980 Renken" 18 ft bow rider 140hp 400 omc stringer ...can the large transom seal be changed without dropping the outdrive also.. had tilt clutches replaced this summer while on...
See more
Top