Recent content by mrmark1

  1. M

    Bravo One U-Bolt

    thank you for the reply. purchased new gimble ring, waiting on mechanic to install .just wanted to make sure not a safety issue.
  2. M

    Bravo One U-Bolt

    mechanic snapped off one of the studs while tightening u-bolt .is it safe to use until it is replaced ?
  3. M

    Reverse Issues

    2005 Bravo outdive, forward works perfectly ,no reverse unless give it a bit of throttle then it will engage. mechanic tried to adjust cables but did not help.
  4. M

    stern light flickers

    stern light flickers when the nav lights are on,but when anchor light is on light does not flicker
  5. M

    which prop(new to me used boat)

    1) Performance issue you are trying to correct. (wot rpm with current prop is to high) 2) Current prop manufacturer, model, aluminum or stainless as a minimum. (stainless,elite series high five mercury) 3) Current prop diameter and pitch (required). (19) 4) Wide open throttle RPM and speed with...
  6. M

    Service manual for 2005 496 HO

    just checking to see if anyone has a electronic copy/pdf service manual that they would be willing to share thank you
  7. M

    pre purchase inspection

    can anyone recommend a certified surveyor in the bullhead city az. area?
  8. M

    what is considered low hours

    looking at buying a new used boat. it is a 2004 with a 496
  9. M

    repairing section of floor with seaboard

    had a soft 2' x2' section of plywood floor. Cut out bad area, now would like to fill in area with 1" seaboard. Question is will 3M 5200 adhesive hold the seaboard to the existing plywood and fiberglass stringers?
See more
Top