Recent content by ncornett1

  1. N

    Replaced Impeller now linkage messed up.

    93' Johnson 60hp. J60TLETD. Replaced impeller. Put lower unit back on with prop in neutral and throttle handle set at neutral. Shift rod went back up under motor and i hooked it back into the stud under the motor, but for some reason the throttle linkage is now about a 1/2 inch forward of...
  2. N

    Bad Primer Solenoid

    I've posted a few times about a 93 Johnson 60 hp motor that is hard to start. After more investigation, there is no clicking sound from the primer solenoid when i turn the key and push in to choke. However there are 13 volts or so that are being measured to the solenoid itself. I'm thinking...
  3. N

    1993 Johnson 60 - No Start

    This is a great board! I have a J60TLETD motor , serial #G 03311022. Will not start unless red primer lever is moved to manual start. I put a can of tuning oil in it, let it soak, and cleared it. Also put new plugs in it. Still won't turn over when primer lever is in RUN position, i have to...
  4. N

    EVERYONE READ THIS AND PLEASE HELP!

    Have a J60TLETD motor , serial #G 03311022. What year is this motor? Also, I posted earlier on gas leaking from my carbs. I was thinking a carburetor disassemble was in order(i have the shop manual) until the following happened... I had disconnected the fuel line and cleaned off gas spill...
  5. N

    GAS LEAKING

    Have a J60TLETD motor , serial #G 03311022. Won't start cold unless I turn primer solenoid to manual start. Runs good. When I stop, I have to repeat procedure. Noticed when I pushed in choke, gas dripped a lot out below silencer cover. This is a 92 or 93 year motor. I'm thinking about...
See more
Top