Recent content by Nonyab

  1. N

    2000 Johnson 50 Tilt/Trim Rebuild

    I have a 2000 Johnson 50PL with the tilt leaking badly at the top seal and cannot remove the air. My efforts to remove the tilt from the motor so far have not been successful. I will get it off--- but then--- I have already run into a problem finding the proper rebuild instructions. I have never...
  2. N

    1992 Evinrude 90 Sync/Link Adjustment

    I have been doing a sync & link on this 90. I have found all the information I need except for one(1) little tidbit that I cannot find in any shop manual or OMC factory video. Does anyone know what the "initial" length/adjustment of the throttle cam follower rod is suppose to be? All else on...
  3. N

    1986 Johnson 25 Tiller Handle

    Can anyone tell me where I can get a wiring diagram for a 1986 Johnson 25 HP electric start? I have converted a manual start to electric start and the wiring of the neutral safety switch has me puzzled. The top of the switch has two terminals on one metal strip which gives continuity at all...
  4. N

    1992 Evinrude 90 Water from Lower unit Splitline

    Before replacing the water pump on this engine there was water coming from along the gear case split line. The water pump was working fine but since the motor is new to me and had been setting for some time I wanted to check the condition of the impellor. After replacing the water pump and...
See more
Top