Nordin's latest activity

  • N
    Nordin replied to the thread Reeds?.
    About setting the timing, on these Chrysler and Force engines you just set the timing at WOT. Timing at idle will be what it will be...
  • N
    Nordin replied to the thread Reeds?.
    My experience is to give some throttle and sometimes some choke even if warm. Have a Mercury Thunderbolt 800 80Hp 1972, same actions...
  • N
    Nordin reacted to Capt dave 258's post in the thread 125 Force ignition wiring? with Like Like.
    Thank you, Nordin. After cleaning up a bit of corrosion and hooking up the wires as you indicated, I was able to get the switch to work...
  • N
    Nordin replied to the thread Reeds?.
    As you have removed the carbs and intake manifold I would suggest to do the link and sync as Frank A that is in the top of this forum...
  • N
    Nordin replied to the thread Reeds?.
    Some light thru the reeds are acceptable but not to large gap. 0,10mm (0,004in) in my opinion is acceptable. Remember that these...
  • N
    Nordin replied to the thread 125 Force ignition wiring?.
    Check out Mastertech Marine (maxrules.com) they have wiring diagram. Look at technical specification-common wiring diagram and then...
  • N
    Nordin replied to the thread Yamaha 25hp 2stroke outboard.
    Looking at the video and it sounds like it is misfiring. Do as 99yam40 suggest, check with a timing light. Also check the sparkplugs for...
  • N
    Nordin replied to the thread Force 85 hp control cable questions.
    This is a link to a YouTube video how to connect and adjust the remote control. Paste this in your browser or google it and you should...
  • N
    Nordin reacted to Chris1956's post in the thread First Successful Outing On The Lake with Like Like.
    OK, to set the shift cable on that motor: Set the MerControl to neutral. Remove both shift and throttle cables from their clamps...
  • N
    Nordin replied to the thread 90hp outboard died suddenly, wouldn't restart.
    The engine need three things to run. 1. Air/fuel mixture (right amount mixture) 2. Compression 3. Spark (at the right time) Troubleshoot...
  • N
    Nordin replied to the thread 90hp outboard died suddenly, wouldn't restart.
    You have to check for spark at all three plugs. I sounds like there is no spark. If the stator goes bad you will loose spark at all plugs.
  • N
    Nordin replied to the thread 1986 85hp force 856X6L no spark.
    Okey, I have one question. How did you split the CD module and how did you remove the insulation putty? I think it is easy to repair the...
  • N
    Nordin replied to the thread 1986 85hp force 856X6L no spark.
    Sounds like you have one output channel at one CD module that is bad. Each CD module has two output channels soo a two cylinder engine...
  • N
    Nordin replied to the thread Reeds?.
    I use razor blades, pocket knifes or putty knifes when removing old gaskets at smaller parts. At lager parts/surfaces such as bottom of...
  • N
    Nordin replied to the thread can starter spin fly wheel just fast enough for stator to show power but not trigger the triggers?.
    I do not really know the answer of your question but I think if the starter turn the flywheel fast enought to generate power to the CDI...
Show older items
Top