I got some HF discs and I like Baylinerchuck's quote Let' er eat. It does eat. I got about the motor attachment area done before it started to rain and I had to shut it down. Thanks again I am on my way.
Been on 12 hr shifts, off for weekend, back at it on Monday. Since the transom is out I went out to grind the peanut butter remnants or whatever it is. Went at it for 2 hrs with an orbital sander w/ 36 grit and a dremel w/ oscillating blade and got about maybe 8" worth cut out. Here comes the...
It is part of the cap. There is an inner wall and the cap making the outer wall. My thought is to cut the outer wall cap about foot and replacing it. Would also like to add some bracing along the sides (not sure of the term maybe called knees)
Thanks for your photos. That is pretty much what I had in mind but put the trough back in down the center. In your photos I see that you have the side walls cut out also. At this point I only have the floor removed. I kind of want to take my side walls out also but I am a little afraid of...
The trough acted like it had two stringers but it is only about a quarter inch thick. In the bow it had hatch maybe for the anchor and the trough was a way for water to get to the bilge area. Towards the rear there might have been a ski locker and seating. A former owner cut it out and put the...
Here is where I am at right now. Transom and deck out and most of the foam gone. Thanks GSP for your response. I do want to put a couple of stringers in. I think I will take your advice and put foam back in. I will have to do some research on that part. I read in one of the posts about foam...
First off just a little history of this boat. This is a 1981 14.5 ft Center Console little boat for fishing. I brought this boat from my brother is 2002 and took it out a few times. The 50 hp Mercury needed some work done to it. I removed the motor an started the work it needed. Some how the...
