Need installation manual.Got this used with no info. Putting it on 1975 Meyers Bay Runner,would like to know what the install recommendations are before I blow holes thru the new transom wood I will be installing. I wrote to T-H Marine but haven't heard back from them.
Swapped input wires on coils, failure followed input wire. I do not have a DVA for testing.
Also not much of a CDI guy, this is above my points and condenser skill level.
What are the common issues for this problem
Swapped input wires on coils, failure followed input wire. I do not have a DVA for testing.
Also not much of a CDI guy, this is above my points and condenser skill level.
What are the common issues for this problem
Cleaned carbs replaced float needles and fuel lines ran OK. Found out I needed to make sure carbs were re-synced and fully closing after re installing carbs, did that. Re adjusted Idle jets.Starts fine and if throttle is opened quickly it runs like a raped ape. But if I gradually ramp up the...
This one hasn't been in the water for 8 yrs and as far as I know never had lower unit lube changed.
Got about 3/4 cup water out it when I drained it, so I knew it may need a new oil seal.
After changing lube and running with the rabbit ears within a few days I had lube weeping from three small...
This one hasn't been in the water for 8 yrs and as far as I know never had lower unit lube changed.
Got about 3/4 cup water out it when I drained it, so I knew it may need a new oil seal.
After changing lube and running with the rabbit ears within a few days I had lube weeping from three small...
I was in in the process of replacing fuel lines when after removing the starter for access I found these lines.
I find nothing in the parts diagrams or Seloc Manual about them. There are two plastic 90s and a tee in the center.
They are both cracked in half and also the 90s and the tee are...
