Recently came into virtually a "free" boat. 1985 Sea Ray 270 Sundancer with a 2005 Loadmaster 30 ft. tri axle trailer. Trailer was for storage only and perfect. The boat......actually in really nice shape,no soft spots in hull,decks or transom. Inside of cabin is about an 8 out of ten with one...
After looking at all the engine specs in the shop manual.....is it only the carb size which would complete a 9.9 to 15 hp conversion.?? Bore,stroke etc. all appear to be the same for both models. I bought what I thought ws a 15hp motor but after checking serial /model# found out it was a 9.9...
I have been rebuilding a 1974 9.9 Evinrude. Replaced all the waterpump components....however when I went to replace the waterjacket gasket with the parts I got from the iboats parts section the waterjacket gasket...although similar dd not quite match up. Also most of one side of the old gasket...
Picked up an engine with a 15 hp cover and the following #s on Plate
Model 10424S serial# E0003478
I assume this is a 9.9 hp engine and I think the year is 1974......am I close in my research. Thanks for the help.....Peter
Hi, recently was given a light twin which had been sent in for service/tune-up and then owner passed away several years ago. Engine cover a bit faded but inside was in mint condition. Started up with 32:1 to be on safe side. Engine started and ran great however im not familiar with the cooling...
Hi...Ive been posting about a gearcase leak on an 83 90hp v4...as I was draining the lower unit I see that both of the screws..... drain and level check DO NOT have washers. The shop manual says to remove/replace washers. I was goung to drop the lower unit to pressure test it..My question is...
OK...drained gearcase and had a good amount of water run out...ordered a lower unit seal kit..Question?? what is most likely source of leak? if lower o-ring went bad would this let water in...or would it most likely have come from another source.(higher up,such as water pump)..causing the lower...
First...thanks for all your help so far...its amazing the wealth of information on these boards...OK I posted earlier about gear case lube leaking ...thought it was the prop shaft bearing seal...but after further examination I believe it is farther back in the bearing carrier...my question...I...
Hey all...seem to get conflicting answers on year of my v4 90hp...model#90TLCTE serial#Jo271528......if anyone could help ...would be appreciated..thanks!
Hi..have an 87 evenrude v4 90hp motor ...has slow drip at prop. from gear oil...can the seals behind the prop be removed from the outside and new ones pressed in...or does the lower unit need to be torn apart and seals changed from inside...thanks for any help...Peter
