Hi Guys.
Really hope someone might be able to help me out here:
I have a 1991 Evinrude 30hp two cylinder.
Is it possible to replace the lower crank case seals without splitting the case itself? (Realise I'll have to lift the power head whatever)
The reason I'm asking is because every few...
Hi.
Hope someone can help me here as I'm really struggling. I have a Garmin 152 GPS with external antennae. I have now bought a Cobra DSC VHF radio. I'm trying to interface the two without success. The GPS has 5 wires (apart from the red pos and black neg) these colours are: blue, white, green...
Hi..have tried to find out the info on the web....with no success. Be really gratefull if anyone could date my O/B. It's a Mariner 2 stroke 2cylinder 40hp serial number S004938. It's a pull start and the plate says made in Japan. Are they any good...just bought it?
Any help really appreciated...
Hi. I have a 1991 Evinrude 30hp pull start outboard. It was on a boat I bought recently. I have had a great deal of trouble starting it. Strange thing is I found out by accident a 'sort' of way to start it: Position remote throttle at idle....purge extra fuel a couple of times.....pull starter...
Hello everyone. I have a Yamaha Malta 3hp I bought second hand as a back up engine. It starts/runs great, however there didn't seem to be a stream of cooling water coming out from the hole half way up the leg. I had a look at the impellor...which seemed fine so put it back together. Now the...
Hi everyone.
I've a 90's 3 cylinder 60hp Mariner engine. The overheat warning in hte remote box is not very loud. I'd like to fit a temperature guage by the speedo/rev counter. Is there an aftermarket kit, I mean, i a car I'd just get a generic sensor and jubilee clip it inside a water hose?
Any...
Hi. Really hope someone can advise me here.
I've got a Metzler 12 foot inflatable with a floor that inflates hard and flat. The boat is rated up to 15HP (stamped on the tube). Now then, I acquired a Volvo Penta 14hp outboard as a non-runner. I've got it running now...GREAT! Trouble is, the...
Hello.
Wonder if anyone can help me here? I've just bough a boat with a 60hp Mariner/Mercury engine. The serial number is OC2474862. Can anyone tell me the age of the engine please? Also, what can I expect in terms of Galls. per hour at WOT?
Regards
Howard
Hi. Really struggling here.
Bought the engine (exc. cond) as a runner but not pumping water. I've stripped down the pump casing and replaced the impellors (2) two rotary shaft seal and the gaskets. STILL won't pump water.
I've checked the obvious....no obstructions on the inlet side & the...
Hi. Hope someone out there can help. I've just purchased a Suzuki DT50 serial number 204772. Can anyone help with dating this engine please?
Regards
Howard
Any of you guys help me here? <br />I've bought the Seloc manual, but there's no reference to a start up procedure. It's a Mercury 50, 1985 4 cylinder with carbs and Thunderbolt ignition.<br />The control lever has F N R. You can also pull out the lever to enable revs to be applied without drive...
Hi.<br />Hope someone can give me an idea here. What sort of mpg or gph should I be looking for on my 1985 4 cyl. Mercury 50 Gold Band with thunderbolt ignition? Is there any way to improve it, additives, props etc?<br />It's on a 14ft Fletcher speed boat, if this makes any difference?<br...
Could really do with some help on this on please?<br />I've bought a boat with a Mercury outboard. It was sold to me as a 50hp. I'd like to order spares but can't date the engine. The plate with the serial number is missing..bit worried about that!! Also it's been sprayed over...even more...
HELP..Can't date my Mercury outboard!
Could really do with some help on this on please?<br />I've bought a boat with a Mercury outboard. It was sold to me as a 50hp. I'd like to order spares but can't date the engine. The plate with the serial number is missing..bit worried about that!! Also...
