GOOD NEWS. . . . The PICTURE UPLOAD FUNCTION IS WORKING !!! The tech folks at the parent company have been able to remedy the issue. You can upload pictures once again. Thank you for your patience.
Can someone please confirm the correct procedure for connecting the B+ lead to a 12 volt source when timing a 2000 / 3.0 GS PEFS engine. Does the lead get connected before or after engine start.
New circulating pump last spring, raw water impeller 2 weeks ago, new thermostat, and engine overheats. Ran the hose in and out and back and forth and water seems to be flowing unrestricted. Can anyone suggest next steps?
I removed the raw water pump to check the impeller and noticed that the plastis tubes are not solidly attached to the pump. The seem to be loose. ( I can move them side to side by an eigth of an inch ) I ran the engine prior to removing the pump and there were no leaks from the hose attach...
My 2000 Volvo 3.0 GS will run @150-160 degrees all day long at 3500 RPM or less. At 3500 and above the temp starts rising and at WOT move toward overtemp. When this happens I reduce the RPM and the temp falls quite rapidly back to the 150-160 level. I removed the thermostat and it obviously...
I've done some testing following the troubleshooting procedure / schematic provided on this site and everything seems to check out Ok but I still have the same problem. The trim won't move in either direction when I hit the switch on the throttle but the relays click. I can move the foot by...
My Trim / Tilt pump is intermittent. The plastic connector on the harness going to the pump motor seemed loose so I hard wired it which didn't solve the problem. The relays klick when I toggle the trim button on the throttle but the pump doesn't work. I haven't taken the relays out of the...
New to the group. 2000 Volvo 3.0 runs great except idle won't go below 900 in gear. Occasionally diesels at shut down. Will be doing a tune up on the weekend and would like to know if I should adjust the idle mixture ( carb still has the plastic caps on the idle mixture screws ) or leave as is...
